Microfoane de studio Neumann TLM 49

Studio microphone with Retro look. Warm sound, optimized for vocal recordings. Uses the capsule of the legendary M 49 and U 47.
Cardioid polar pattern. Set includes elastic suspension.

Applications

During the development phase, the sound was adjusted in extensive practical tests, so as to make the TLM 49 ideal particularly for vocal and speech recording. However, in addition, it is also suitable for instrumental applications in professional production studios and demanding home recordings.

Vocal microphone: Lends richness, power and brilliance to the voice, while remaining balanced and transparent
Announcer’s microphone for broadcasting, dubbing and voice-overs
Spot microphone and for recording e.g. strings, piano and guitar
These are just some of the most common applications. We recommend additional experimentation to gain maximum use from this microphone.

Polar pattern

The large-diaphragm capsule of the TLM 49 provides a cardioid directional characteristic with a tendency toward supercardioid, due to the special capsule construction. Following the example of the M 49, high frequencies are more directional. The capsule diameter is 34 mm.

The front of the microphone is indicated by the red Neumann logo on the microphone body. The capsule is oriented so that the microphone is addressed from the front.

Acoustic features

The TLM 49 uses the famous K 47 capsule, which was also used in the M 49 and the U 47. The capsule has a linear frequency response up to the upper mid-range. Above 2 kHz there is a gentle presence boost up to 3 dB.

The capsule is enclosed by a large microphone headgrille, which is acoustically very open and is hence neutral with regard to the sound.

Electrical features

The letters TLM stand for “transformerless microphone”. With TLM technology the usual output transformer is replaced by an electronic circuit.

As with traditional transformers, it ensures good common mode rejection, and prevents RF interference that may influence the balanced audio signal.

Noise signals which affect the balanced modulation line are therefore effectively suppressed. The microphone can operate at sound pressure levels of up to 129 dB without distortion, and provides a dynamic range of 117 dB (A-weighted).

Operational safety

The entire interior structure is mounted elastically, to prevent the transmission of structure-borne noise. In addition, the capsule is mounted with a rubber shock mount.

Due to the wide frequency response, the TLM 49 can also transmit extremely low-frequency signals without coloration. Of course this means that the microphone is also sensitive to noise signals such as vibration noise and wind noise in this frequency range. The TLM 49 is therefore supplied with the elastic suspension EA 3, which effectively protects the microphone from structure-borne noise. If the microphone is addressed at extremely close range, pop screen PS 15 or PS 20 a can be used in front of the microphone to provide protection against plosive sounds.

Features

Sound profile optimized for vocal performance
Pressure gradient transducer with the large-diaphragm capsule of the legendary U 47
Cardiod characteristic
Retro design
Transformerless output circuitry
Acoustically very open wire mesh headgrille
Complete set with elastic suspension

Technical Data

Acoustical operating principle Pressure gradient transducer
Directional pattern Cardioid
Frequency range 20 Hz ... 20 kHz
Sensitivity at 1 kHz into 1 kohm 13 mV/Pa
Rated impedance 50 ohms
Rated load impedance 1 kohms
Equivalent noise level, CCIR (1) 23 dB
Equivalent noise level, A-weighted (1) 12 dB-A
Signal-to-noise ratio, CCIR (1) (rel. 94 dB SPL) 71 dB
Signal-to-noise ratio, A-weighted (1) (rel. 94 dB SPL) 82 dB
Maximum SPL for THD < 0.5 % (2) 110 dB
Maximum SPL for THD < 5 % (2) 129 dB
Maximum output voltage for THD < 5% (2) -1 dBu
Dyn. range of the mic. amplifier /A-weighted, 0.5 % (2) 98 dB
Dyn. range of the mic. amplifier /A-weighted, 5 % (2) 117 dB
Supply voltage (P48, IEC 61938) 48 V ± 4 V
Current consumption (P48, IEC 61938) 3.2 mA
Matching connector XLR 3F
Weight 825 g
Diameter 78 mm
Length 165 mm

__________________________________________
1) according to IEC 60268-1; CCIR-weighting acccording to CCIR 468-3, quasi peak; A-weighting according to IEC 61672-1, RMS
2) measured as equivalent el. input signal, k2 dominant

Interactive view of diagrams (click pe poza) Interactive view of diagrams

Livrarea include:

TLM 49 microphone
EA 3 Elastic suspension

Accesorii pentru TLM 49
[EA 2] [PS 15] [PS 20a]

Neumann Large Diaphragme Transistor
[TLM 102] [TLM 103] [TLM 193] [TLM 49] [TLM 67] [U 87]

Garantie: 24 luni.

(Pagina anterioara)

Microfoane Neumann TLM 49
clic pe poza pt. marire
Pret: la cerere
Cumpara
Disponibilitate:
la comanda
TLM 49 studio microphone: Detail view of the microphone body
TLM 49 studio microphone: Detail view
TLM 49 studio microphone: Detail view
clic pe poza pt. marire
 
 
Copyright 2005-2016© Video’S srl
Toate drepturile rezervate